Aerospace, Vol. 10, Pages 244: Performance Analysis and Optimization of Fuel Tank Ground-Based Washing Inerting on Unmanned Aerial Vehicles

Aerospace, Vol. 10, Pages 244: Performance Analysis and Optimization of Fuel Tank Ground-Based Washing Inerting on Unmanned Aerial Vehicles

Aerospace doi: 10.3390/aerospace10030244

Authors: Chaoyue Li Huan Yang Sha Liu Shiyu Feng Lei Xu Zhiling Wang

In this study, a ground-based washing inerting (GBWI) method was proposed, and the application of GBWI in the field of fire prevention and explosion suppression of unmanned aerial vehicle (UAV) fuel tanks was studied using a volume of fluid (VOF) two-phase flow model at a given typical flight envelope. The variation in oxygen concentration in tank ullage during flight was calculated considering the entrance of ambient air and the escape of dissolved oxygen from the fuel. The results indicate that the oxygen concentration in the ullage increases with increasing initial oxygen concentration in the ullage and the initial fuel load after GBWI. In the climb and cruise stages, the oxygen concentration in the ullage increases slowly, while in the tactical descent stage, the oxygen concentration in the ullage increases rapidly, easily exceeding the limiting oxygen concentration (LOC) of aviation fuel combustion. To expand the application range of GBWI, an optimization scheme of nitrogen filling protection was proposed so that the GBWI could meet the requirements of an inert tank at different fuel loads and initial oxygen concentrations in the ullage. Compared with a traditional on-board inert gas generation system (OBIGGS), the optimized GBWI method could greatly reduce the fuel compensation loss and improve the maneuverability of UAVs at the same time.