Energies, Vol. 17, Pages 1713: Influence of the Skin and Proximity Effects on the Thermal Field in Flat and Trefoil Three-Phase Systems with Round Conductors

Energies, Vol. 17, Pages 1713: Influence of the Skin and Proximity Effects on the Thermal Field in Flat and Trefoil Three-Phase Systems with Round Conductors

Energies doi: 10.3390/en17071713

Authors: Paweł Jabłoński Marek Zaręba Tomasz Szczegielniak Jerzy Gołębiowski

The passage of current generates heat and increases the temperature of electrical components, which affects the environment, support insulators and contacts. Knowledge of the temperature allows for the determination of important operational parameters. Time-varying currents result in a nonuniform current density distribution due to the skin and proximity effects. As a result, temperature and energy losses are increased compared to the uniform DC current density case. In this paper, these effects are considered for three-phase systems with round conductors in flat and trefoil arrangements. In the first step, the analytical expressions for current distributions are determined and used to construct the heat source density. Then, a suitable Green’s function, which allows for obtaining temperature distribution in analytical form, is used to evaluate temperature at any point throughout the conductors. The temperature differences throughout individual wires are usually negligible, whereas noticeable differences can be observed between the wires. The impact of various parameters is examined, and an approximate closed formula is derived to assess the influence of the skin and proximity effects. When the skin depth is not smaller than the wire radius, the skin effect enlarges the temperature increase by around 2% compared to the DC case. As for the proximity effect, the additional increase can be neglected if the distance is above around 10 wire radii, but for closely spaced wires, it can reach up to around 17%, depending on the arrangement and the distance between the wires. Such an additional increase may result in exceeding the permissible temperatures, which damages particular components of the system; therefore, it is important to take it into account at the design stage.