Materials, Vol. 17, Pages 1840: Microstructural Characteristics and Properties of Laser-Welded Diamond Saw Blade with 30CrMo Steel

Materials, Vol. 17, Pages 1840: Microstructural Characteristics and Properties of Laser-Welded Diamond Saw Blade with 30CrMo Steel

Materials doi: 10.3390/ma17081840

Authors: Qiang Xu Chen Shu Yibo Liu Shengzhong Kou Rui Cao Xiaodie Cao Jiajun Wu

In order to enhance the quality of diamond composite materials, this work employs a Cu-Co-Fe and Ni-Cr-Cu pre-alloyed powder mixture as a transition layer, and utilizes laser-welding technology for saw blade fabrication. By adjusting the laser-welding process parameters, including welding speed and welding power, well-formed welded joints were achieved, and the microstructure and mechanical properties of the welded joints were investigated. The results demonstrate that the best welding performance was achieved at a laser power of 1600 W and a welding speed of 1400 mm/min, with a remarkable tooth engagement strength of up to 819 MPa. The fusion zone can be divided into rich Cu phase and rich Fe phase regions, characterized by coarse grains without apparent preferred orientation. The microstructure of the heat-affected zone primarily consists of high-hardness brittle quenched needle-like martensite, exhibiting a sharp increase in microhardness up to 550 HV. Fracture occurred at the boundary between the fusion zone and the heat-affected zone of the base material, where stress concentration was observed. By adjusting the welding parameters and transition layer materials, the mechanical properties of the joints were improved, thereby achieving a reliable connection between diamond composite materials and the metal substrate.