Processes, Vol. 12, Pages 444: A Numerical Study on the Process of the H2 Shaft Furnace Equipped with a Center Gas Distributor

Processes, Vol. 12, Pages 444: A Numerical Study on the Process of the H2 Shaft Furnace Equipped with a Center Gas Distributor

Processes doi: 10.3390/pr12030444

Authors: Shan Yu Lei Shao Zongshu Zou

In order to explore technically feasible options for improving the performance of the H2 shaft furnace (HSF), a previously built and validated computational fluid dynamics (CFD) model was employed in the current work to assess the potential of the operation based on a center gas distributor (CGD). A set of simulations was performed to mimic scenarios where different amounts of feed gas (0–30% of 1400 Nm3/t-pellet) are injected via the CGD located at the bottom of the HSF. The results showed that a relatively large stagnant zone (approximately 8.0-m in height and 0.3-m in diameter) exists in the furnace center where the gas flows are weak owing to an overly shortened penetration depth of the H2 stream solely injected from the circumferentially installed bustle-pipe. When adopting the CGD operation, however, the center gas flows can be effectively enhanced, consequently squeezing the stagnant zone and thus leading to a better overall performance of the HSF. In particular, the uniformity of the final reduction degree (mean values ranging from 0.8846 to 0.8896) of the solid phase (i.e., pellets) is well improved under the investigated condition where the total gas feed rate is fixed at 1400 Nm3/t-pellet. As for the final mean reduction degree of solid and top gas utilization degree, the two performance indicators rise to maximal values when the CGD feed ratio is increased to 20% and then slightly drop with a further increase in the ratio.